Announcement

Collapse
No announcement yet.

Valve stem seals

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Valve stem seals

    Todays task was to change stem seals, these were my key to success. I made an adapter from old sparkplug to pressurize the cylinder.



    Not much left of the old ones


    I've used better tools but this one was quite OK too



    Less than three hours they were all changed

  • #2
    Good job! Next, take your rocker shafts off and clean out all the oil holes, in the rocker arms and shafts. CLICK HERE Back in the day we used non-detergent oil. Sediment filled the rocker arm holes and eventually plugged them. A small drill bit or stiff steel wire will open them again. Old stagnant oil remains in the shafts that turns to light grease. Be careful, it will not come out of your clothes. This cleaning costs nothing to do. If you find your shafts are worn, they are available at the parts stores.

    I never liked the 'umbrella' seals from back in the day. They harden, split, travel with the valve stem and sometimes they break. In any case, they sure don't do a very good job of holding oil back.

    Modern heads use Viton seals. They have a circular spring that holds them on the tower and they don't harden. The old stuff was made from straight neoprene.

    Keep up the good work. - Dave
    My latest project:
    CLICK HERE to see my custom hydraulic roller 390 FE build.

    "We've got to pause and ask ourselves: How much clean air do we need?"
    --Lee Iacocca

    From: Royal Oak, Michigan

    Comment

    Working...
    X