Tweet
I am about to remove the front wheel cylinders on my 60...is the nut that holds them on a 1 1/4" or 1 5/16"?
-
390, Mild Cam, Headers, 3.70 rear, 2-1/2" Exhaust, Edelbrok Performer RPM Intake, Holley Street Avenger 670 Carburetor, One Wire Alt, Petronix Ignition. She's All Go and No Show. -
brake wheel cylinder
I just remove the complete front end this past week end. I used a 1 1/4 six point socket. The correct size is 1 3/16, but I did not have one. The 1 1/4 fits on but a little loose. -
Thanks
Thanks...I used a 1 1/4 one came off OK, the other had to be chiseled off. Do you think that the 1 1/4 inch nuts and locking tab washers are available?390, Mild Cam, Headers, 3.70 rear, 2-1/2" Exhaust, Edelbrok Performer RPM Intake, Holley Street Avenger 670 Carburetor, One Wire Alt, Petronix Ignition. She's All Go and No Show.Comment
Comment