If this is your first visit, be sure to
check out the FAQ by clicking the
link. You must register
before you can post: click the register link to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I suggest the best way is to use a plate that bolts on to your intake where the carb would normally go. The attached pic is a friend's 351 that let go big time, you can see a commercially available version on the top of the engine. I made mine with flat plate, welded and drilled to suit. The three holes allow you to vary the angle that the engine/trans comes out at. Use it in conjunction with an engine hoist that has an adjustable tilting boom attachment thingy (can't think of the right word) and you'll be sweet.
Thanks for that Petrolhead. I was thinking about using the intake, but wasn't sure if it would handle the weight of the engine until I get it onto the stand. I will give this a try.
Please give that 351 a proper burial...looks like a horrible dis-memberment.
thinking about using the intake, but wasn't sure if it would handle the weight of the engine until I get it onto the stand.
I used my one to lift a complete 302 Windsor and a T5 five-speed out as one unit, admittedly lighter but no probs.
Penelope, the 351 is out of a XB Falcon that races in the muscle car class, let go at full noise down Pukekohe Park Raceway's back straight. They didn't need tools to get the broken bits out, just reached inside the ventilated block/sump and grabbed them...
Reminds me of a line I read somewhere about wiring: "be sure to connect correctly otherwise you'll let the smoke out, and once trhe smoke is out it's very hard to get it back in".
Comment