Removing Rear Window Regulator and Motor
Per my post, I have to remove my power window motor, as it does not seem to be working. I have diagnosed this all the way from the switches and 15A circuit breaker, confirming the power is getting to the motor in the Up & Down Switch modes. Green Wire is live, and Red & Yellow act accordingly. Ensured by grounding to the circuit breaker.
I post pictures below to point out the required bolts removed. I had to also disengage the vertical slide because the window stuck in the UP position, binds and does not allow the regulator enough freedom to access the mounting nuts atop the motor.
I carefully lowered the window down. I will proceed to clean up and re-grease the regulator, and try to repair the motor, though it's probably easier to just buy a re-manufactured one from one of the many parts catalogs.
I can re-assemble the vehicle if I want to drive her around, but I will probably leave it open for now until I figure out what to do with the motor.
Hopefully the figures in the shop manual will be enough for re-assembly, plus I took a dozen pics...
See pics below:
Per my post, I have to remove my power window motor, as it does not seem to be working. I have diagnosed this all the way from the switches and 15A circuit breaker, confirming the power is getting to the motor in the Up & Down Switch modes. Green Wire is live, and Red & Yellow act accordingly. Ensured by grounding to the circuit breaker.
I post pictures below to point out the required bolts removed. I had to also disengage the vertical slide because the window stuck in the UP position, binds and does not allow the regulator enough freedom to access the mounting nuts atop the motor.
I carefully lowered the window down. I will proceed to clean up and re-grease the regulator, and try to repair the motor, though it's probably easier to just buy a re-manufactured one from one of the many parts catalogs.
I can re-assemble the vehicle if I want to drive her around, but I will probably leave it open for now until I figure out what to do with the motor.
Hopefully the figures in the shop manual will be enough for re-assembly, plus I took a dozen pics...
See pics below:
Comment