Tweet
does anyone know the guage of sheet metal used for the rear frames (the u shaped section that starts under the back seat and goes up over the rear end and ends up over the gas tank)?
also, does anyone know the guage of sheetmetal used for the bottom ribbed, insidevertical that makes of the interior well, and intermediate part of the rocker panel?
need to do a little repair in these areas and would be nice if someone had the spec's as opposed to trying to determine thicknesses in the field.
also, does anyone know the guage of sheetmetal used for the bottom ribbed, insidevertical that makes of the interior well, and intermediate part of the rocker panel?
need to do a little repair in these areas and would be nice if someone had the spec's as opposed to trying to determine thicknesses in the field.