Working on the interior now. Pulled out the black/purple carpet, degreased and prepped the flooring to put more KBS coating on the rust. Driver side was more rusty with a minor hole which will be filled. Once the driver side coating is dried thoroughly I'll start cleaning the passenger side to do the same. That should finish up my can of KBS RustSeal.
Used KBS' RustBlast that leaves a zinc coating for better adhesion of the rust coating.
The only real rust hole in the front
RustSeal
Also re-did the wiring harness. I use the stuff that Harbor Freight sells.
I bought a 4'x24' roll of floor padding/sound deadening material from JC Whitney for less than $60. That'll go over most of the floor and behind and under the backseat. I took the gunk-filled master cylinder off and will clean that section of the firewall for painting, and then install the new one. Once that's in I can finally start bleeding the brakes.
Then, new tires to replace the old Firestone 721's that are really shot.
Used KBS' RustBlast that leaves a zinc coating for better adhesion of the rust coating.
The only real rust hole in the front
RustSeal
Also re-did the wiring harness. I use the stuff that Harbor Freight sells.
I bought a 4'x24' roll of floor padding/sound deadening material from JC Whitney for less than $60. That'll go over most of the floor and behind and under the backseat. I took the gunk-filled master cylinder off and will clean that section of the firewall for painting, and then install the new one. Once that's in I can finally start bleeding the brakes.
Then, new tires to replace the old Firestone 721's that are really shot.
Comment