HI,
Psg side rear window problems!!!
The window has a new motor which works but the window does not operate properly. It appears upon inspection that someone before me might have remove the whole assy. I say this because the window doesn’t track correctly up or down. The window goes well below the sill line in the down position, which it shouldn’t (compared drv side rear for comparison). It also is about 2 ½ inches or more from the rear stop hitting the metal below. It will also try to start to pull the regulator arm (top arm) away from the rail and snap the roller off. I used some shims to help alleviate this, but I don't fel this is the soilution, since it helped but I still have problems.
When going up it will but will be about 1 1/2 inches short before getting to the top, then will start to move forward. Like it’s already reach its high point.
I believe that the regulator is out of phase with the worm gear connected to the regulator and is causing these problems. I did adjust the eccentric bushing etc, without any luck so I believe it not that since it’s basically a 360 degree adjustment. There are three of them .
I was hoping that the regulator could be phase correctly and put back in. Any ideas on how to do this would be greatly appreciated. Any other ideas will be welcome as well!
Thanks- Jack
Thanks
Jack
Psg side rear window problems!!!
The window has a new motor which works but the window does not operate properly. It appears upon inspection that someone before me might have remove the whole assy. I say this because the window doesn’t track correctly up or down. The window goes well below the sill line in the down position, which it shouldn’t (compared drv side rear for comparison). It also is about 2 ½ inches or more from the rear stop hitting the metal below. It will also try to start to pull the regulator arm (top arm) away from the rail and snap the roller off. I used some shims to help alleviate this, but I don't fel this is the soilution, since it helped but I still have problems.
When going up it will but will be about 1 1/2 inches short before getting to the top, then will start to move forward. Like it’s already reach its high point.
I believe that the regulator is out of phase with the worm gear connected to the regulator and is causing these problems. I did adjust the eccentric bushing etc, without any luck so I believe it not that since it’s basically a 360 degree adjustment. There are three of them .
I was hoping that the regulator could be phase correctly and put back in. Any ideas on how to do this would be greatly appreciated. Any other ideas will be welcome as well!
Thanks- Jack
Thanks
Jack
Comment