Hello TBird friends,
may be someone out there can give the following information?
While I work on the underbody I fond at four positions the plates as you see at the attached picture.
When I disconnected the screw and plate I found four oval holes.
I think that there is something missing and that what I found is only another bad handcraft solution.
Can someone tell me how that detail should look like?
Thanks for reply
whpaul
may be someone out there can give the following information?
While I work on the underbody I fond at four positions the plates as you see at the attached picture.
When I disconnected the screw and plate I found four oval holes.
I think that there is something missing and that what I found is only another bad handcraft solution.
Can someone tell me how that detail should look like?
Thanks for reply
whpaul
Comment