The heads on my 352 have large water jackets on either end of the heads, but so far, I am unable to find head gaskets that have a cutout the same as my water jackets. The front cutout is correct, and the rear cutouts have only a small hole in that location, smaller than the diameter of a pencil. It seems odd to me as these are definitely the right gaskets, I am told, and now two different brand names show the same configuration. Why would anyone want to limit the water flow with a gasket?
What should I do? I was planning on cutting it out myself, but thought I'd see if anyone here had seen this issue before.
Please advise if you've encountered this before.
What should I do? I was planning on cutting it out myself, but thought I'd see if anyone here had seen this issue before.
Please advise if you've encountered this before.
Comment