We recently removed the dash completely, and installed a new cover.
Upon installation, and raising the column back up, now the horn doesn't work.
Removing the blue-yellow wire under the column from the yellow connector, and grounding it, the horn relay and horn works.
That only leaves the blue wire within the column, the contact switch assembly, and the ground of the inner shaft.
Our question is, by lowering the column, is there a movement that would cause the grounding contact assembly to change? Has anyone experienced this?
Upon installation, and raising the column back up, now the horn doesn't work.
Removing the blue-yellow wire under the column from the yellow connector, and grounding it, the horn relay and horn works.
That only leaves the blue wire within the column, the contact switch assembly, and the ground of the inner shaft.
Our question is, by lowering the column, is there a movement that would cause the grounding contact assembly to change? Has anyone experienced this?
Comment