If this is your first visit, be sure to
check out the FAQ by clicking the
link. You must register
before you can post: click the register link to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The knob needs to be all the way in when you push that little brass button on the side to pull it out. It can be a bear. Sometimes you need to do it a few times before the knob lets loose.
Tony,
When you refit the headlight knob you need to push it back in until you hear a CLICK sound and then adjust the knob left or right for brightness of the dome lights on the dash.
Once the shaft is removed you can use a flat head screwdiver and turn the dash bezel to remove the headlight switch.
If you are removing the headlight switch as you have no dome/centre console lights then a new switch should repair the problem
Kev.
Tony,
I forgot to say, to push in that little button you sure need SMALL fingers and to do this job you really need to lie down in the foot well to get the best access.
Kev.
It makes it a lot easier to see what's going on if you remove the temp/gas gauge. Then you can look down through there while getting at it with the screw driver from underneath.
hey thanks for the help,, a little jiggle and a large hole in my thumb released the rod. Oh sorry forgot to mention dash is out in a box with the rest of the car .I wonder how many seperate pieces i have!
I Should post a picture so you can all see what a 59 bird looks like in hundreds of Australian pieces.....:+
Comment