If this is your first visit, be sure to
check out the FAQ by clicking the
link. You must register
before you can post: click the register link to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
After 6 years the replacement drive bushing failed that I replaced when I did the new front motors. Luckily I saved the originals, so went back with that. These replacement parts are not too good!
After 6 years the replacement drive bushing failed that I replaced when I did the new front motors. Luckily I saved the originals, so went back with that. These replacement parts are not too good!
What are you calling a drive bushing? Coupling? Not at all sure what failed unless it was a bearing in the motor.
Nyles
Yes, coupler is the proper term. Both ends are plastic with a keyed shaft hole and they are "tied" together with a rubber covering over them. The rubber disintegrated. The originals still look fine.
Tweet
Comment