If this is your first visit, be sure to
check out the FAQ by clicking the
link. You must register
before you can post: click the register link to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Mark there is also a rubber plug to act as a cushion against the license plate and the bracket that fits in the round hole , the same applies to the top centre hole in the rear bumper and the hole found in the bumper under the flip lid for the gas fill-up .You will find most if not all the T-bird vendors sell the rubber bumpers . Ian
I had a good look at my front bumper. There are two holes spaced about 14 inches apart on the bottom of the overrider which is where I mounted my bracket. I didn't see any place to attach the pictured part.
Ian... you wouldent happen to have a parts breakdown for the trunk on the 62 convertable would you?? Looking for the deck lid limit switch ACTUATOR BRACKET. Thanks Ken
...you wouldent happen to have a parts breakdown for the trunk on the 62 convertable would you?? Looking for the deck lid limit switch ACTUATOR BRACKET...
This will give you your Ford part numbers and the layout.
Comment