I received this email from Chris - Tbird Timemachine regarding his '66 Landau Tbird. Apparently, he is having problems posting. Here is what he had to say.
"Yes, I could use some help I guess. I had a hard time submitting my post.... Anyhow, I am new to the hobby and not very knowledgeable about cars in general. Luckily, I have my Dad who is a mechanic of sorts. I just got my timemachine a couple of months ago so we needed to do a few things. 1) change the brake lines 2) replace alot of gaskets and seals. We replaced the intake manifold gaskets since they were leaking really bad in the front and back. Problem is, now the driver side is making a 'ticking' noise. Initially, we had a different kind of noise sounded really bad and fairly loud which we found was the valves rubbing against the oil pan or whatever that plate thing is below the rocker arm. So we bent the plate away to make clearance and it was much better. Now, we have this 'ticking' or 'clattering' noise which appears to be coming from the valves or push-rods going up and down. Almost as if they need more lubrication or something. Any ideas? Good news is no leaks! Also, we are not sure where to run all the vacuum lines and do not know how to reattach the linkages. Any help with these matters or any tips in general would be appreciated by this novice."
I have tried to communicate via email with him, but he must not have my personal email addresses in his address book and I guess they went into his Spam folder. Perhaps he will see your responses to his problems here.
"Yes, I could use some help I guess. I had a hard time submitting my post.... Anyhow, I am new to the hobby and not very knowledgeable about cars in general. Luckily, I have my Dad who is a mechanic of sorts. I just got my timemachine a couple of months ago so we needed to do a few things. 1) change the brake lines 2) replace alot of gaskets and seals. We replaced the intake manifold gaskets since they were leaking really bad in the front and back. Problem is, now the driver side is making a 'ticking' noise. Initially, we had a different kind of noise sounded really bad and fairly loud which we found was the valves rubbing against the oil pan or whatever that plate thing is below the rocker arm. So we bent the plate away to make clearance and it was much better. Now, we have this 'ticking' or 'clattering' noise which appears to be coming from the valves or push-rods going up and down. Almost as if they need more lubrication or something. Any ideas? Good news is no leaks! Also, we are not sure where to run all the vacuum lines and do not know how to reattach the linkages. Any help with these matters or any tips in general would be appreciated by this novice."
I have tried to communicate via email with him, but he must not have my personal email addresses in his address book and I guess they went into his Spam folder. Perhaps he will see your responses to his problems here.
Comment