This will take you to the main site where there is history, technical information and other information on these cars.
This takes you back to the main page of the forums.
This is the control panel to change your password, information and preferences on this message board.
Click here if your lost your password or need to register on this message board. You must be a registered user to post. Registration is free.
Search this board for information you need.
Click here to buy cool Squarebirds mechandise.
Click here to support Squarebirds.org. For $20 annually receive 20mBytes webspace, a Squarebirds e-mail address and member's icon on the message board.
  #1  
Old 01-23-2012, 07:11 PM
NewBird13 NewBird13 is offline
Newbie
 
Join Date: Jan 13 2012
Posts: 24
NewBird13 is on a distinguished road
Default Hey everyone, Glad to be here.

Hey everyone.
I found this site about a month ago and have been loving all of the great advice. I just thought I would share how I came to be on this site.
A while back my fiancee was telling me how she wanted to drive away from our wedding in a classic car. I knew she was referring to renting one but I jokingly said how about you let me get a project and ill have it done on time for the wedding? My chin is still hurting from hitting the floor after she said " sure babe go ahead".
Collectively we started looking in the newspaper, craigslist, ebay and anywhere else you can think of for our wedding car. A few weeks ago day on Craigslist I found her," 1959 Ford Thunderbird project, with all parts." I was hooked and so was my fiancee.
I contacted the seller and it all sounded too good so I had to drive up and check it out.
While checking it out I had to try my best to hide my excitement (still wanted to haggle somewhat). The whole car was very solid with very few rust spots that need repair (trunk and front fender skirts) The engine hasnt started in 20 years but still spins. The interior is complete but needs to be redone. I ended up grabbing it for about half of what others birds in the same condition are going for.
The car gets here this week and I couldnt be more stoked! The plan of action to first get her mechanically sound then to get her looking pretty.
So many questions have gone through my head, keep it original or make it tweak it a bit? Keep the 352 go to a 390? Original color or black or red with the white top? Deal with the original drum brakes or do the disc brake conversion? How much do I want to let the machine shop do and how much do I think I can do?
Like I said I just wanted to say hello and thank everyone in advance because I am sure that I am going to have a barrage of questions and I know that I have found the mecca of T Bird knowledge.
Looking forward to it
Sean
Reply With Quote
  #2  
Old 01-23-2012, 08:04 PM
Anders's Avatar
Anders Anders is offline
Moderator
 
Join Date: Jan 19 2008
Posts: 2,160
Anders is on a distinguished road
Default

The golden rule is: Build it the way YOU want it, so YOU enjoy it! In your case, your fiancee is included in "YOU"
For sure, our cars works great for weddings! This is from when my daughter got married
Attached Images
File Type: jpg IMG_3962-1.jpg (65.4 KB, 80 views)
__________________
..."Lil darling Ruth"
http://www.tbirdregistry.com/#33158

Last edited by Anders : 01-23-2012 at 08:33 PM.
Reply With Quote
  #3  
Old 01-23-2012, 08:05 PM
DKheld's Avatar
DKheld DKheld is offline
Super-Experienced
 
Join Date: Aug 27 2008
Posts: 1,443
DKheld is on a distinguished road
Default

Sean,

Great story and glad you found the site. Hope the project is a real hit at the wedding and please take pics to show us. You do have a bunch of decisions to make but in the end it will be your car so make it like you want it.

You're right - there are plenty of helpful folks on this site - hope to hear more soon on the progress and post some pics of the car when you can.

Eric
registry 5347
http://www.tbirdregistry.com/viewdat...tryNumber=5347
Reply With Quote
  #4  
Old 01-23-2012, 08:40 PM
Restifier52's Avatar
Restifier52 Restifier52 is offline
Experienced
 
Join Date: Jul 26 2011
Posts: 356
Restifier52 is on a distinguished road
Default

Welcome to the community! Be sure to look at the technical bulletins. They are great. My son will be getting married in about two years ( they haven't set the date yet, both still in school) and he asked me if they could use the car. I've got a lot of work to do this coming season.

Rick in Clarkston, MI
__________________
1960 HT
Thunderbird Registry #35780
Reply With Quote
  #5  
Old 01-23-2012, 08:43 PM
lawyercalif lawyercalif is offline
Experienced
 
Join Date: May 12 2011
Posts: 240
lawyercalif is on a distinguished road
Default

I hope your fiancÚ is a patient woman, because if you do all the things you mentioned the wedding could be a long way off. Have fun with this project but do not let it get you in trouble with the lady in your life.
Reply With Quote
  #6  
Old 01-23-2012, 10:00 PM
Richard D. Hord Richard D. Hord is offline
Super-Experienced and Proud Kentuckian who bleeds Ford Blue.
 
Join Date: Dec 16 2008
Posts: 2,868
Richard D. Hord is on a distinguished road
Default

Hey Sean,
Welcome! Lawyercalif may be right There are so many awesome things that can be done to these old Birds to get them up to date (If you plan on driving it) Keep us posted and we will help all we can!
Richard D. Hord

P.S. "Christine" and my wife still don't get along :O
__________________
'60 Thunderbird "Christine"
Registry #33436
Reply With Quote
  #7  
Old 01-24-2012, 01:30 AM
simplyconnected's Avatar
simplyconnected simplyconnected is offline
Slow Typist
 
Join Date: May 26 2009
Posts: 7,163
simplyconnected is on a distinguished road
Default

Sean, be careful not to do things twice or three times. Carefully plan your restoration steps.

It helps to know how your car was built:
First it was a steel body with welded parts.
Then it was painted as an empty shell.
Next, they installed wire harnesses, glass, carpet, dash, seats, and all the trim.

Off to the side, the engine and trans was married, and the rear end was chosen. Those parts went into a painted steel body, and so did the suspension (upper & lower "A" arms, coil springs, shocks, sway bar, spindles, brakes, exhaust, steering wheel and tie rod components, etc).

My point is, for example, if you decide to change front springs, that would be the time to change suspension bushings, ball joints, shocks, and rubber bumpers because all those parts will be very accessible (or removed) while the springs are out. It is much cheaper, faster, and easier to restore all of these at once.

If you decide to take your engine out for an overhaul, plan on power washing and painting the empty engine bay.

If your engine has high-miles, smokes, etc, overhaul the entire engine, not half of it. Engine parts all work together. Reconditioning just the heads will cause your old rings to fail because they can no longer sustain 'new' compression for very long. Doing a complete overhaul uses only one inexpensive gasket set compared to buying gaskets individually or multiple times.

The guys are telling it straight... a good restoration takes many years to do properly. And the sign of a good restoration is, there is no way to see that things are restored. Many restorations end up half done because this is going to take a lot of time, money, and tenacity. Never buy a classic car as an investment. If you aren't passionate about your restoration, it probably won't get done.

Get pictures of how your finished car SHOULD look, and plaster your garage walls with them. There is a light at the end of this tunnel. Keep your eyes on it. Otherwise, buy a car already restored. In this economy, they are around for cheap.

Hope this helps. - Dave
__________________
My latest project:
CLICK HERE to see my custom hydraulic roller 390 FE build.

"We've got to pause and ask ourselves: How much clean air do we need?"
--Lee Iacocca
Reply With Quote
  #8  
Old 01-24-2012, 09:59 AM
SandyBoy SandyBoy is offline
Super-Experienced
 
Join Date: Oct 31 2002
Posts: 842
SandyBoy is on a distinguished road
Default

Beatiful Thunderbird
Beautiful Bride
Handsome Groom
What more is there ?
Reply With Quote
  #9  
Old 01-24-2012, 12:09 PM
jopizz's Avatar
jopizz jopizz is offline
Excellent Auto Mechanic for over 40 years.
 
Join Date: Nov 23 2009
Posts: 4,883
jopizz is on a distinguished road
Default

There are many different levels of restoration. Some will put thousands of dollars into a car to make it better than when it left the factory. When doing a squarebird hardtop this usually means putting more money into then you will ever get out of it if you want to sell it. As much as I like a car I always look at the bottom line when I do a restoration. That's just me. As mentioned it's your car and you should restore it to your tastes. You are not going to offend any purists by changing the color to something you prefer and making it mechanically to suit your taste and driving style. It's not a limited production car. I would always recommend a disc brake conversion if you are going to drive it more than just occasionally. The power assist drum brakes on a '59 can be scary if you are used to today's cars. If you have the know how by all means do as much of the work yourself as you can. You'll be surprised how much of an obsession it becomes.
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -4. The time now is 10:04 AM.

Driving, racing or working on cars can be hazardous. The procedures and advice on this website including the message board are opinion only. Squarebirds.org and its webmasters and contributors do not guarantee the correctness of the advice and procedures. The Squarebirds.org and its webmasters assume no liability for any damage, fines, punishment, injury or death resulting from following these procedures or advice. If you do not have the skills or tools to repair your car, please consult a professional. By using this site you agree to hold harmless the Squarebirds.org, its authors and its webmasters from any resulting claim and costs that may occur from using the information found on this site.

Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Any submissions to this site and any post on this site becomes property of Squarebirds.org . The webmasters reserve the right to edit and modify any submissions to this site. All material on this is site is copyrighted by the Squarebirds.org. Reproduction by any means other than for personal use is strictly prohibited. Permission to use material on this site can be obtained by contacting the webmasters. Copyright 2002-2016 by Squarebirds.org.