This will take you to the main site where there is history, technical information and other information on these cars.
This takes you back to the main page of the forums.
This is the control panel to change your password, information and preferences on this message board.
Click here if your lost your password or need to register on this message board. You must be a registered user to post. Registration is free.
Search this board for information you need.
Click here to buy cool Squarebirds mechandise.
Click here to support For $20 annually receive 20mBytes webspace, a Squarebirds e-mail address and member's icon on the message board.
Old 09-17-2010, 12:12 AM
62 bullitt 62 bullitt is offline
Join Date: Jul 22 2009
Posts: 13
62 bullitt is on a distinguished road
Default Turn signal

Turn signals stoped working, keep blowing fuses!!! any thoughts before I start chasing gremlins everywhere?
Reply With Quote
Old 09-17-2010, 01:22 AM
ozbird ozbird is offline
Join Date: Sep 22 2009
Posts: 38
ozbird is on a distinguished road

My 62 did that and the horn wire was broken causing shorts but not all the time - if you can disconnect horn wire/relay it might show the fault up? I had to remove the steering wheel and hub etc to get to the wire but while there you will get a good look at the wiring for the signal switch.

Reply With Quote
Old 09-18-2010, 03:04 AM
62 bullitt 62 bullitt is offline
Join Date: Jul 22 2009
Posts: 13
62 bullitt is on a distinguished road

Thanks, I'll check it out. Was thinking about replacing the detent plate for which I'll have to remove the wheel anyway.
Reply With Quote
Old 09-18-2010, 04:40 PM
simplyconnected's Avatar
simplyconnected simplyconnected is online now
Slow Typist
Join Date: May 26 2009
Posts: 7,609
simplyconnected is on a distinguished road

Most of these kinds of fault are caused by exposure to the weather. Most obvious corrosion in a lamp socket can either open or short a circuit.

There are other causes as well. Frayed wires from rubbing on sharp metal edges mixed with vibration is a recipe for a good short.

Most recently, Eric found his license plate bulb socket was grounded. That caused his headlight switch to click, and his tail lights stopped working. I know this isn't a turn signal, but the socket was exposed to weather, much like your front signal lamps are.

Do you have a trailer pigtail? 'Sounds silly, but some T-birds pulled trailers (right, Ray?). Look for the evidence and make sure your wires/connector are protected.

Unplug your lamps and troubleshoot from there. - Dave
My latest project:
CLICK HERE to see my custom hydraulic roller 390 FE build.

"We've got to pause and ask ourselves: How much clean air do we need?"
--Lee Iacocca
Reply With Quote
Old 10-06-2010, 08:58 PM
Larry Jones Larry Jones is offline
Join Date: Feb 3 2009
Posts: 265
Larry Jones is on a distinguished road
Default turn signals

Hello. I would look on the inside nearthe parking brake and make sure the lower harness is tight against the outside of the firewall. There our two harnesses coming in from that location through the firewall make sure there tight. If in question pull the carpet back and pull the lower plug out the outer clip on the firewall side will hold the outside in place while you can pull the lower plug from inside. Might want to spray some electronoc cleaner on the male and female plugs as I did. Larry.
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

All times are GMT -4. The time now is 07:27 PM.

Driving, racing or working on cars can be hazardous. The procedures and advice on this website including the message board are opinion only. and its webmasters and contributors do not guarantee the correctness of the advice and procedures. The and its webmasters assume no liability for any damage, fines, punishment, injury or death resulting from following these procedures or advice. If you do not have the skills or tools to repair your car, please consult a professional. By using this site you agree to hold harmless the, its authors and its webmasters from any resulting claim and costs that may occur from using the information found on this site.

Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Any submissions to this site and any post on this site becomes property of . The webmasters reserve the right to edit and modify any submissions to this site. All material on this is site is copyrighted by the Reproduction by any means other than for personal use is strictly prohibited. Permission to use material on this site can be obtained by contacting the webmasters. Copyright 2002-2016 by