This will take you to the main site where there is history, technical information and other information on these cars.
This takes you back to the main page of the forums.
This is the control panel to change your password, information and preferences on this message board.
Click here if your lost your password or need to register on this message board. You must be a registered user to post. Registration is free.
Search this board for information you need.
Click here to buy cool Squarebirds mechandise.
Click here to support Squarebirds.org. For $20 annually receive 20mBytes webspace, a Squarebirds e-mail address and member's icon on the message board.
  #1  
Old 03-05-2017, 01:41 PM
19thunderbird59 19thunderbird59 is offline
Newbie
 
Join Date: Jun 13 2016
Posts: 3
19thunderbird59 is on a distinguished road
Smile Hot console on 59 Tbird

My console feels very hot while driving on the freeway. The engine seems to be at normal temperature. Does anyone have any ideas why this happens? Thanks for any suggestions.
Reply With Quote
  #2  
Old 03-05-2017, 01:49 PM
jopizz's Avatar
jopizz jopizz is offline
Excellent Auto Mechanic for over 40 years.
 
Join Date: Nov 23 2009
Posts: 4,874
jopizz is on a distinguished road
Default

Your console is right above the transmission tunnel so it will get hot. You can try removing it and putting some insulation under it.

John
__________________
John Pizzi - Squarebirds Administrator
1959 Convertible

Thunderbird Registry #36223
jopizz@verizon.net 856-779-9695

http://www.squarebirds.org/picture_gallery/TechnicalResourceLibrary/trl.htm
Reply With Quote
  #3  
Old 03-06-2017, 11:57 AM
DKheld's Avatar
DKheld DKheld is offline
Super-Experienced
 
Join Date: Aug 27 2008
Posts: 1,443
DKheld is on a distinguished road
Default

From my experience it's just the "nature of the beast". Mine also is like that. The exhaust pipes run together directly under the tunnel also contributing to the heat. Could possibly try wrapping the exhaust with heat tape so that the heat stays in the pipes and is transferred further back. Maybe the exhaust pipes are very thin and that would cause it?



Sounds similar to the problem on our MGA's. Heat from the engine compartment and exhaust manifolds funnels down the transmission tunnel only adding to the heat (and with thin wooden floorboards on the MG's it really becomes a problem!!!).

As John mentions - about all we can do is add insulation to block the heat.


Eric
Reply With Quote
  #4  
Old 03-06-2017, 02:26 PM
Yadkin Yadkin is offline
Banned
 
Join Date: Aug 11 2012
Posts: 1,910
Yadkin is on a distinguished road
Default

It's normal. But it's also very easy to insulate the top of the tunnel under the console finish materials.
Reply With Quote
  #5  
Old 03-08-2017, 02:05 AM
sidewalkman's Avatar
sidewalkman sidewalkman is offline
Experienced
 
Join Date: Sep 14 2015
Posts: 304
sidewalkman is on a distinguished road
Default

When I did the carpet in mine I completely gutted the interior of carpet, seats and console. I then completely covered almost every exposed area with Dynamat. Not only did it make a HUGE difference in the amount of road noise coming through but also dropped the interior temp a few degrees. The whole thing cost I think about 120 bucks so it was well worth it.
__________________
Scott
South Delta, BC, Canada
1960 White T-Bird, PS, PB that's it
Red Leather Interior!
www.squarebirds.org/users/sidewalkman
Thunderbird Registry #61266
http://www.squarebirds.org/picture_g...ibrary/trl.htm
Reply With Quote
  #6  
Old 03-18-2017, 06:04 PM
bygrace's Avatar
bygrace bygrace is offline
Apprentice
 
Join Date: Jul 27 2015
Posts: 33
bygrace is on a distinguished road
Default hot floors

I agree on the dynamat idea. It helped when I did it along with vintage air. No need to let the AC fight those floors. I remember how hot they were driving it home from CA across AZ, NV. I couldn't keep my hand on the chrome strip on the console. But what REALLY helped make a difference was exhaust pipe heat shields I made later. All I used was roofing aluminum from the hardware store. Cut to 5 or 6 inch widths and whatever lengths fit between the bends in the pipe. Add about 3 inches of length on each end, and cut the ends into three 3 in. tabs. ( Think of a block capital letter "E".) Bend each tab down 90 and then back up 90 in about an inch. Roll the whole length into a half-round shield. The letter " E" makes three legs to stand the heat shield off the pipe an inch, and the part of each leg past the second bend is simply hose- clamped to the pipe. I put them in clear to the back seat floor. I thought about making them over using stainless of something better, but they work fine and I never felt the need. I don't know, but maybe the wrap mentioned would do as well. But this sure does make a difference. I guess the heat is reflected and carried out the rear of the shield. Let the forum know if you find out how the wrap works.
Reply With Quote
  #7  
Old 03-23-2017, 06:39 PM
byersmtrco's Avatar
byersmtrco byersmtrco is offline
Administrator
 
Join Date: Sep 28 2004
Posts: 1,611
byersmtrco is on a distinguished road
Default

Look at it this way, you set your coffee cup there, it'll stay warm.
In ancient Ford mechanic terms
"They all do that"

See a few posts down re; the custom 58 w/cup-holders.
__________________
John Byers
1960 Convertible (Orig owner)
Pic of car with my son Justin (15 Y/O 6'1")
Poss 3rd Gen T/B owner
Reply With Quote
  #8  
Old 03-24-2017, 09:40 AM
Yadkin Yadkin is offline
Banned
 
Join Date: Aug 11 2012
Posts: 1,910
Yadkin is on a distinguished road
Default

Maybe someone can correct me, but these engines are at best, what, 30% efficient? More or less anyway. So 70% of the fuel you purchase ends up as heat instead of turning the drive wheels. At normal highway speeds you're consuming about 4 gallons per hour, so you have, in effect, a gasoline fire consuming about 2.8 gallons an hour, or about 320,000 BTUs.

The typical home furnace puts out about 100,000 BTUs.
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -4. The time now is 06:59 PM.

Driving, racing or working on cars can be hazardous. The procedures and advice on this website including the message board are opinion only. Squarebirds.org and its webmasters and contributors do not guarantee the correctness of the advice and procedures. The Squarebirds.org and its webmasters assume no liability for any damage, fines, punishment, injury or death resulting from following these procedures or advice. If you do not have the skills or tools to repair your car, please consult a professional. By using this site you agree to hold harmless the Squarebirds.org, its authors and its webmasters from any resulting claim and costs that may occur from using the information found on this site.

Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Any submissions to this site and any post on this site becomes property of Squarebirds.org . The webmasters reserve the right to edit and modify any submissions to this site. All material on this is site is copyrighted by the Squarebirds.org. Reproduction by any means other than for personal use is strictly prohibited. Permission to use material on this site can be obtained by contacting the webmasters. Copyright 2002-2016 by Squarebirds.org.