Thread: Holley 4160
View Single Post
Old 04-26-2016, 04:17 PM
sidewalkman's Avatar
sidewalkman sidewalkman is offline
Join Date: Sep 14 2015
Posts: 357
sidewalkman is on a distinguished road

Originally Posted by pbf777 View Post
The screw Holley states to remove is in order to allow the A.T. "kick-down" lever to operate on the carburetor linkage shaft. Allowing this lever motion, along with a cap-screw, threaded nut & return spring are intended for attachment & operation of the "kick-down" rod linkage which is used on C4 & C6 transmission applications. On these applications a single steel tube linkage attaches from the carburetor kick-down lever down to the transmission's lever.
This is not applicable in your installation, if you retain the C.O.M. transmission & factory linkage. Scott.
Perfect, thanks. The instructions were rather vague.
South Delta, BC, Canada
1960 White T-Bird, PS, PB that's it
Red Leather Interior!
Thunderbird Registry #61266
Reply With Quote