View Single Post
Old 09-13-2012, 03:22 PM
Anders's Avatar
Anders Anders is offline
Join Date: Jan 19 2008
Posts: 2,165
Anders is on a distinguished road

A little update how I solve this. First I made a aluminium piece in my lathe, and have it welded into the carburator spacer. Then I made another in steel, that I also drilled out in the back, so it didnīt came out too heavy, with a tight slightly coned end to get a nice fit and pressed that in gently and to avoid leak, and gave it a few spot welds to keep it in place. ( The part that goes into the manifold was not possible to take out, so this was my only option ) In between, I placed the PCV valve. Pretty easy installation. Hope to get less fumes while driving as well as less oil on the garage floor
Attached Images
File Type: jpg IMG_2049.jpg (661.4 KB, 61 views)
File Type: jpg IMG_2051.jpg (677.1 KB, 61 views)
File Type: jpg IMG_2052.jpg (694.6 KB, 62 views)
File Type: jpg IMG_2053.jpg (416.4 KB, 61 views)
File Type: jpg IMG_2054.jpg (706.2 KB, 60 views)
..."Lil darling Ruth"

Last edited by Anders : 09-13-2012 at 03:32 PM.
Reply With Quote