After reading several post it seems it is an easy swap from a 352 to a 390 using same exhaust manifols, motor mounts and tranny on a FE motor.
I have located a 1974 390 FT motor with the 428 crank and bored.30 over, basicly a rebuilt motor, with the 2barel setup.
Can I swap out that engine with the same luck?
Was told I can without any problem from seller.
I was going to take the 352 heads off my motor and put on the 390, along with my 4 barrel intake and carb.
Will this work OK?
Thanks
I have located a 1974 390 FT motor with the 428 crank and bored.30 over, basicly a rebuilt motor, with the 2barel setup.
Can I swap out that engine with the same luck?
Was told I can without any problem from seller.
I was going to take the 352 heads off my motor and put on the 390, along with my 4 barrel intake and carb.
Will this work OK?
Thanks
Comment