View Single Post
  #2  
Old 02-26-2018, 11:14 AM
pbf777 pbf777 is offline
Experienced
 
Join Date: Jan 9 2016
Posts: 207
pbf777 is on a distinguished road
Default

Quote:
Originally Posted by mh434 View Post
you should only apply RTV to the front and back of the block sealing edge.Jon
A thin coat of sealant about the water ports, if evidence of corrosion pitting, and as a substitute for the cork seals upon the "china-walls" to intake surfaces front & back, is as I would advise.

Also, note as to whether your engine has the alignment pin pressed into the block (front china-wall), to register the position of the intake upon mounting; if not, you will want to insert the distributor (dizzy) for referencing the proper front to back position prior to tightening the retaining bolts.

Scott.
Reply With Quote