Anyone identify this part?

[Guest]

Hi all

This part came with my 61 convertible. It may be NOS or has been repainted. Any ideas?

Cheers

Mark

[Guest]

this part

Mark, any casting #'s that you can make out Jeff

[Ian M Greer]

Mark that your front license plate bracket that mounts on your centre bumberette, black is it's true colour. Ian

[Guest]

Thanks Ian

And to think I spent 2 hours fabricating a front license plate holder out of aluminum!!!

Mark

[Ian M Greer]

Mark there is also a rubber plug to act as a cushion against the license plate and the bracket that fits in the round hole , the same applies to the top centre hole in the rear bumper and the hole found in the bumper under the flip lid for the gas fill-up .You will find most if not all the T-bird vendors sell the rubber bumpers . Ian

[Guest]

Ian

I had a good look at my front bumper. There are two holes spaced about 14 inches apart on the bottom of the overrider which is where I mounted my bracket. I didn't see any place to attach the pictured part.

Regards
Mark

[Ian M Greer]

Hope this photo helps, Ian

[Ian M Greer]

Mark sorry photo's sideways , note bracket 17A385 mounts by two screws #35483-S to bumperette #17996 hope this helps, Ian

[YellowRose]

Anyone identify this part?

I don't know if this helps, but this is what it looks like on a '62 Bulletbird.

[Ian M Greer]

Same set-up , thanks Ray. Ian

[Guest]

Thanks for the information guys. I'll take another close look at my bumper but I don't recall any holes in that position.

Mark

[Guest]

Well, a closer look revealed the plate for the license holder in the bumper overrider. None so blind....

Mark

[skyliner57]

photo

Hope this photo helps, Ian

Ian... you wouldent happen to have a parts breakdown for the trunk on the 62 convertable would you?? Looking for the deck lid limit switch ACTUATOR BRACKET. Thanks Ken

[simplyconnected]

...you wouldent happen to have a parts breakdown for the trunk on the 62 convertable would you?? Looking for the deck lid limit switch ACTUATOR BRACKET...

This will give you your Ford part numbers and the layout.

Here's a closer look:

- Dave

[simplyconnected]

Alright, let's show both top and bottom sections:




How's this? - Dave