While I have the front end all torn out I decided to tackle the PS components since they were completely covered in about 1/4" of crud.
Trying to figure out how to get the bushing and the other seal out of the piston end of the cylinder. The shop manual says to pull the piston rod all the way out, but I can't get it to come all the way out and have only removed the snap ring, scraper and one seal.
Any advice on how to get the rest out?
Thanks!
Trying to figure out how to get the bushing and the other seal out of the piston end of the cylinder. The shop manual says to pull the piston rod all the way out, but I can't get it to come all the way out and have only removed the snap ring, scraper and one seal.
Any advice on how to get the rest out?
Thanks!
Comment