I was about to plum the valve and the ram and realized I did not take note of how the lines were connected before removing them. According to the manual the back port on the valve goes to the back port on the ram and same for the front ports on the two parts. (The orientation of the ports is as they are attached on the vehicle. The back port is the back of the car, front port is the front of the car)
Is this correct? I'll only get one chance at it, if I'm wrong then it's back to the parts store for another tube.
Thanks again.
Is this correct? I'll only get one chance at it, if I'm wrong then it's back to the parts store for another tube.
Thanks again.
Comment