Had new tires out on the tbird today. The car has some spoke rims on it, date stamped from 1989. When they took off the old tires there were inner tubes in it. I was surprised to see that knowing that the tires were modern tires and before they were off today I new the wire spoke rims were from 1989.
Well I have one just 3 hours later is half flat, others the tire pressure is down from the amount I put in myself after the intall (seemed low).
Do I need to put the inner tubes back in the tires? When the tires were off the rims there was an opoxy on the inside of rims near the bead place the tire would need to seal. All 4 were that way as if they were safeguard from the spokes????? I thought a 1989 make spoke rim would not be an issue
The shop cleaned up the tire to rim seal point, they were not bad when taken apart.
Do I have a rim issue or a shop did not do a good job issue?
Well I have one just 3 hours later is half flat, others the tire pressure is down from the amount I put in myself after the intall (seemed low).
Do I need to put the inner tubes back in the tires? When the tires were off the rims there was an opoxy on the inside of rims near the bead place the tire would need to seal. All 4 were that way as if they were safeguard from the spokes????? I thought a 1989 make spoke rim would not be an issue
The shop cleaned up the tire to rim seal point, they were not bad when taken apart.
Do I have a rim issue or a shop did not do a good job issue?
Comment