As I have trouble reversing with a warm engine, I'm having a guy look at it. However as there is a bit of confusion over the trans dipstick he wants to make sure I know what engine, trans etc. I have. So....
I have the following on the block to the rear of the generator.
C1AE6015C and 0 (or O) J6:4
On the head I have
C2AE9425C and 1914:
From what I've found from a search on here that means the block is a 1961 390 ? Not sure on the head.
I also need to find the transmission number as thats where the current problems lie. Is it on the side of trans above where the square sump pan is ?
I also measured the incorrect trans dipstick that I have ...
From the bottom to the 2 nubs near the top that I believe someone else mentioned , is 26". To the middle of the bottom rivet is 17". From the bottom to the letter L is 2" with the mark being 2 1/4 ". The F mark is 2 5/8" and thje bottom of the F is 2 3/4". Do these measurements make sense to anyone ?
Thanks again for any help.
I have the following on the block to the rear of the generator.
C1AE6015C and 0 (or O) J6:4
On the head I have
C2AE9425C and 1914:
From what I've found from a search on here that means the block is a 1961 390 ? Not sure on the head.
I also need to find the transmission number as thats where the current problems lie. Is it on the side of trans above where the square sump pan is ?
I also measured the incorrect trans dipstick that I have ...
From the bottom to the 2 nubs near the top that I believe someone else mentioned , is 26". To the middle of the bottom rivet is 17". From the bottom to the letter L is 2" with the mark being 2 1/4 ". The F mark is 2 5/8" and thje bottom of the F is 2 3/4". Do these measurements make sense to anyone ?
Thanks again for any help.
Comment