I purchased an exhaust kit which I regret now. I thought it would all bolt up and save some money. But it has issues so I will need to make some adjustments. At first I thought the spacer missing at the manifold connection on the rh side may have been the issue but this is not the case.
The first issues I have is it hits on the steering arm, I'll have to adjust the bend here.
Also the left and right side are in two halves off the exhaust manifold, and the crossover pipe don't align.
My question is what spacing should I been looking for between the left and right pipes at the crossover pipe?
I assume the pipes then run parallel with the tail shaft for some distance, till it hooks over the rear axle.
Hello from Australia