Thread: Roll pin
View Single Post
  #1  
Old 01-08-2004, 07:58 PM
1960Bird 1960Bird is offline
Experienced
 
Join Date: Dec 4 2002
Posts: 159
1960Bird is on a distinguished road
Default Roll pin

I am going to install a new shift lever and collar and I need to know what size the roll pin is supposed to be, the best that I could measure was .199 diameter or about 13/64 of an inch X 1 inch long, although I assume that it is worn quit a bit and I may not be getting a true reading. Thanks.


Steve Ronk
Cedar Rapids, Iowa
1960 HT 390 cu in, Edelbrock RPM intake, shorty headers, two and one half inch exhaust and 3.70 rear gears...if you are going to go in style you might as well go fast
__________________
390, Mild Cam, Headers, 3.70 rear, 2-1/2" Exhaust, Edelbrok Performer RPM Intake, Holley Street Avenger 670 Carburetor, One Wire Alt, Petronix Ignition. She's All Go and No Show.
Reply With Quote