so the skinny so far
drivers side floor is a mess (got the pans already delivered front and back but will need to do some fab as well)
passenger side front pan needs to be replaced (have that too)
My biggest concern atm is the sheet metal where the seat goes. the upper is not so bad but the lower undercarriage part needs to be replaced and that's not something I can just order apparently. I'm thinking about just getting a sheet of 18g steel and running a piece from the firewall all the way back to the rear seat floor, just to make the undercarriage look right to me. thoughts?
So you can see they cut a hole in the console to make it a floor shift (haha classy)
I'm a little confused on the shifter indicator for the 3 speed manual no parts catalog has them?