View Single Post
  #1  
Old 06-11-2009, 01:05 PM
gaffney1951 gaffney1951 is offline
Super-Experienced
 
Join Date: May 29 2007
Posts: 553
gaffney1951 is on a distinguished road
Default Trunk lid gasket fit ...

I'am installing a new trunk gasket on the 60'. There is no gasket now to compare to and the pics I have been able to find don't show enough detail. From the pics I've seen the gasket goes on the trunk lid, correct? From looking at the gasket I have it almost seems it would have to be installed on edge to seal. Also the lid does'nt fit evenly around the perimeter of the trunk. It fits right at the top and bottum in the center but is 3/8 to 1 /2" low on the bottum outside corners and on the outside edges going up toward the top. I tried putting wood blocks under the outside corners and pushing down on the middle at the trunk latch but it just springs back. Any help much appreciated. Thanks, Mike
Attached Images
File Type: jpg 0906110011.JPG (58.6 KB, 89 views)
File Type: jpg 0906110012.JPG (61.1 KB, 90 views)
File Type: jpg 0906110014.JPG (68.3 KB, 90 views)
Reply With Quote