View Single Post
  #5  
Old 10-02-2017, 04:46 PM
Tbird1044 Tbird1044 is offline
Super-Experienced
 
Join Date: Jul 31 2012
Posts: 1,050
Tbird1044 is on a distinguished road
Default

My car is a 1960 and not sure if it applies to other years, but when I removed my resistor wire, I found a bullet connector at the fire wall in the ignition wire going to the coil. I'm pretty sure that the wire from the first bullet connector to the coil is the resistor wire and the short wire running from the fire wall to the switch is a regular wire. I just replaced the wire from the bullet connector to the coil and got full voltage at the coil. This is a whole lot easier than pulling the switch and replacing the entire wire.
Nyles
Reply With Quote