View Single Post
  #1  
Old 09-15-2017, 12:40 PM
Infinite Monkeys Infinite Monkeys is offline
Apprentice
 
Join Date: Aug 24 2017
Posts: 80
Infinite Monkeys is on a distinguished road
Default Steering control valve to ram fluid line routing

I was about to plum the valve and the ram and realized I did not take note of how the lines were connected before removing them. According to the manual the back port on the valve goes to the back port on the ram and same for the front ports on the two parts. (The orientation of the ports is as they are attached on the vehicle. The back port is the back of the car, front port is the front of the car)

Is this correct? I'll only get one chance at it, if I'm wrong then it's back to the parts store for another tube.

Thanks again.
Reply With Quote