View Single Post
  #8  
Old 02-23-2017, 10:38 PM
RustyNCa RustyNCa is offline
Super-Experienced
 
Join Date: May 31 2007
Posts: 1,300
RustyNCa is on a distinguished road
Default

Quote:
Originally Posted by DKheld View Post
After installing the new engine and chrome valve covers I used a set of spark plug wire holders that attach to the valve cover bolts to route the wires differently. Still a generic set of wires (Advance I think) but a little longer to contour around the valve covers rather than over. Same ends - straight at the plug (but black boot rather than orange) and 90 at the dist.



Eric
That's perfect, what I was planning to do. I picked up a set of tall Weiand finned valve covers for the TBird and never thought about the wires being to short to clear over or around them.

If you click on the small thumbnail it will redirect you to photobucket for a bigger file.

But you can see the cap off a bit to get the wires over the covers.

Thanks for the help, it's very appreciated.

Bryan

Reply With Quote