Squarebirds, Rocketbirds, and Fifties/Sixties Ford Discussion Forum

Squarebirds, Rocketbirds, and Fifties/Sixties Ford Discussion Forum (http://squarebirds.org/vbulletin/index.php)
-   1958 To 1960 Squarebirds - General Technical Discussion (http://squarebirds.org/vbulletin/forumdisplay.php?f=14)
-   -   Painting White walls (http://squarebirds.org/vbulletin/showthread.php?t=21260)

Frango100 01-26-2017 03:32 PM

Painting White walls
 
I did read about cleaning White walls, but is there a good way to paint hem? My White walls are more Yellow walls now, even after cleaning.

sidewalkman 01-26-2017 03:59 PM

Quote:

Originally Posted by Frango100 (Post 106267)
I did read about cleaning White walls, but is there a good way to paint hem? My White walls are more Yellow walls now, even after cleaning.

You can try using white rubber paint but in my experience it's always a disappointment when you see the end result!

Dan Leavens 01-26-2017 11:51 PM

Frank definitely painting the white walls will be a disaster. Go to the Search Button n the main age and type in " Whitewall cleaning " There has been several discussions on our site over the years on how to clean them.

Yadkin 01-27-2017 09:16 AM

My dad used to use a Brillo pad.

scumdog 01-27-2017 01:56 PM

Mine went increasingly brown over a few months, it looked like the black rubber was leaching through from behind the white wall.
Anyway I tried the following to make them white again;
Jiff (liquid scourer)
Hand Andy (ammonia based)
Turtle Wax Cutting compound
Tyre cleaner. ( two types)
Scotchbrite
1200 Wet'n'Dry sandpaper
Abrasive hand-cleaner
Paint thinner
And the only one that worked was turpentine, had to dip a rag in it and rub vigorously and even then they didn't go as white as I would have liked.

sidewalkman 01-27-2017 03:45 PM

Quote:

Originally Posted by scumdog (Post 106292)
Mine went increasingly brown over a few months, it looked like the black rubber was leaching through from behind the white wall.
Anyway I tried the following to make them white again;
Jiff (liquid scourer)
Hand Andy (ammonia based)
Turtle Wax Cutting compound
Tyre cleaner. ( two types)
Scotchbrite
1200 Wet'n'Dry sandpaper
Abrasive hand-cleaner
Paint thinner
And the only one that worked was turpentine, had to dip a rag in it and rub vigorously and even then they didn't go as white as I would have liked.

the best results I've gotten was with a grease cutter and it works slick, sandpaper is not a solution since you're actually getting rid of rubber

YellowRose 10-26-2017 08:31 PM

Painting White walls
 
1 Attachment(s)
Tom ~ scumdog sent me some information and a pic of how he cleans his whitewalls and what they look like before & after.

"Hi Ray, A quick hint for those wanting to get rid of the brown coloration on their whitewall tyres. As you can see there's a difference on this tyre, a 'before' and 'after' sort of thing. I used the green Scotchbrite type pad and wash'n'wax car wash plus some 'elbow grease' to get the whitewall whiter. I tried many products but this method is the best by far that I have tried. It might be handy to put in Squarebirds under 'maintenance' or a similar thread. Regards, Tom."

Here is that pic!

Tbird1044 10-26-2017 11:22 PM

After spend Big $$$ for the rims and wide whitewalls, I think I would go with what the installers are recommending. I was very impressed with the shops knowledge of mounting and balancing of the tires on the wires, and I myself, and my friend, have never had a problem with any of the tires running tubes in them. There are some real horror stories on the site regarding tubes in the wire rims. If you click on the link below, there is a cleaners and accessories tab, with recommended cleaners and how to use them. When this is needed, I am going to go with their recommendations. So far, my ww's are still looking great.
http://www.hobbycar.com/tbird.html
Nyles

sidewalkman 10-27-2017 02:45 AM

Quote:

Originally Posted by Tbird1044 (Post 112018)
After spend Big $$$ for the rims and wide whitewalls, I think I would go with what the installers are recommending. I was very impressed with the shops knowledge of mounting and balancing of the tires on the wires, and I myself, and my friend, have never had a problem with any of the tires running tubes in them. There are some real horror stories on the site regarding tubes in the wire rims. If you click on the link below, there is a cleaners and accessories tab, with recommended cleaners and how to use them. When this is needed, I am going to go with their recommendations. So far, my ww's are still looking great.
http://www.hobbycar.com/tbird.html
Nyles

Um, 13.00 for the cleaner, and then 21.00 for the shipping. you know they're paying at most 5.00 for the shipping. I never understand why companies that might make a good product use shipping as a revenue generator and probably lose half the people who would likely be a return client for years!

Deanj 10-27-2017 12:20 PM

You can try a flexible sanding block from a hardware store. In place of that or with that process use Simple Green applied with a Mr. Clean Magic Eraser or a sponge used to clean smoke on interior walls.

Dean


All times are GMT -4. The time now is 01:32 PM.

Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Any submissions to this site and any post on this site becomes property of Squarebirds.org . The webmasters reserve the right to edit and modify any submissions to this site. All material on this is site is copyrighted by the Squarebirds.org. Reproduction by any means other than for personal use is strictly prohibited. Permission to use material on this site can be obtained by contacting the webmasters. Copyright 2002-2016 by Squarebirds.org.