Squarebirds, Rocketbirds, and Fifties/Sixties Ford Discussion Forum

Squarebirds, Rocketbirds, and Fifties/Sixties Ford Discussion Forum (http://squarebirds.org/vbulletin/index.php)
-   1961 To 1963 Bulletbirds, Rocketbirds - General Technical Discussion (http://squarebirds.org/vbulletin/forumdisplay.php?f=24)
-   -   Idler Arm confusion MFG date 11/61 (http://squarebirds.org/vbulletin/showthread.php?t=19051)

ramos291 06-21-2015 11:02 AM

Idler Arm confusion MFG date 11/61
 
There seems to be a lot of slop/play in the idler arm. I replaced the bushing but the slop/play is still there. Enough play that my alignment shop is unable to do an alignment. What options are there to fix this slop? The bushing is new and suppose to be for the correct MFG date. The mechanic thought maybe the bracket shaft is worn. Replacement of the whole assembly is pricey and i have seen postings of using a 64's assembly. Is there some one that just has the bracket shaft assembly (mounts to the frame)?

simplyconnected 06-21-2015 02:21 PM

The same arm was used from '61-'63. Many of the vendors have this part but it isn't cheap:


Personally, I would remove the bottom parts and carefully inspect the shaft. Then I would consider a repair job instead of spending hundreds on a new one.

I don't know how you feel about 'originality' but you could probably switch to rack and pinion for about the same money. All the slop would be gone and the new system uses fewer joints because there is no counter-shaft. - Dave

Ian M Greer 06-21-2015 09:43 PM

I actual fact there was a difference between bushing diameters from 61/62 dating before 4/4/61 to 3/15/62 sized at 2 7/16 inches long by 5/8 I.D by 19/32 outside diameter. and the later from 3/15/62 which in the Bible is mentioned as ( Upper - 2.312 inches long by .76 ID. The very early 61 before 4/4/61 was a 2.6 inch long and by .63 I. D. bushing . Make sure you have the right bushing (if your going concours , you of coarse want the right one ) Many of the vendors will sell you a replacement design using the heavier made 64 idler arm and bushing set-up which they say is better as the originals were made too thin and weak . Ian

Jerry Forrester 11-26-2015 02:29 PM

The idler arm bushing was worn out on my '62. Dec. '61 build date. I ordered the early bushing from Birdnest. It came in and I attempted to install it. The ID was too small to fit on the shaft. I ordered the later one with the larger ID and everything worked out perfect.
Anybody need a '61-early 62 idler arm bushing?


All times are GMT -4. The time now is 07:26 PM.

Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Any submissions to this site and any post on this site becomes property of Squarebirds.org . The webmasters reserve the right to edit and modify any submissions to this site. All material on this is site is copyrighted by the Squarebirds.org. Reproduction by any means other than for personal use is strictly prohibited. Permission to use material on this site can be obtained by contacting the webmasters. Copyright 2002-2016 by Squarebirds.org.