Squarebirds, Rocketbirds, and Fifties/Sixties Ford Discussion Forum

Squarebirds, Rocketbirds, and Fifties/Sixties Ford Discussion Forum (http://squarebirds.org/vbulletin/index.php)
-   1958 To 1960 Squarebirds - General Technical Discussion (http://squarebirds.org/vbulletin/forumdisplay.php?f=14)
-   -   Roll pin (http://squarebirds.org/vbulletin/showthread.php?t=185)

1960Bird 01-08-2004 06:58 PM

Roll pin
 
I am going to install a new shift lever and collar and I need to know what size the roll pin is supposed to be, the best that I could measure was .199 diameter or about 13/64 of an inch X 1 inch long, although I assume that it is worn quit a bit and I may not be getting a true reading. Thanks.


Steve Ronk
Cedar Rapids, Iowa
1960 HT 390 cu in, Edelbrock RPM intake, shorty headers, two and one half inch exhaust and 3.70 rear gears...if you are going to go in style you might as well go fast

Alexander 01-08-2004 09:53 PM

RE: Roll pin
 
The roll pin for the transmission shift lever is 3/16 inch diameter and 1 inch long.

Alexander
1959 Hardtop
1960 Golde Top

1960Bird 01-09-2004 10:07 AM

RE: Roll pin
 
Thanks Alexander...I couldn't keep this car going without you;-)



Steve Ronk
Cedar Rapids, Iowa
1960 HT 390 cu in, Edelbrock RPM intake, shorty headers, two and one half inch exhaust and 3.70 rear gears...if you are going to go in style you might as well go fast


All times are GMT -4. The time now is 02:05 AM.

Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Any submissions to this site and any post on this site becomes property of Squarebirds.org . The webmasters reserve the right to edit and modify any submissions to this site. All material on this is site is copyrighted by the Squarebirds.org. Reproduction by any means other than for personal use is strictly prohibited. Permission to use material on this site can be obtained by contacting the webmasters. Copyright 2002-2016 by Squarebirds.org.