Squarebirds, Rocketbirds, and Fifties/Sixties Ford Discussion Forum

Squarebirds, Rocketbirds, and Fifties/Sixties Ford Discussion Forum (http://squarebirds.org/vbulletin/index.php)
-   Small Block Ford Engines (http://squarebirds.org/vbulletin/forumdisplay.php?f=70)
-   -   5.4 l SOHC engine (http://squarebirds.org/vbulletin/showthread.php?t=17597)

jhuebner 09-05-2014 03:12 PM

5.4 l SOHC engine
 
Hey guys I can pick up a complete running 5.4l sohc engine with trans for $300, from a 99 Lincoln Navigator anyone know or heard of anyone swapping this engine in a T Bird, sure I will change the intake to a Edelbrock Victor........

Joe Johnston 09-05-2014 03:46 PM

Get the wiring, fuel pump, computer too!!!

jhuebner 09-05-2014 03:51 PM

The guy said I can have the complete drive train, I did a test drive engine and trans pull hard the rest of the vehicle is trashed.

simplyconnected 09-05-2014 05:56 PM

I'm with Joe... get the computer and keep the electronic fuel injection system.

FINSRIN 12-07-2014 06:12 AM

Thatz a low buck price !
Wiring, controllers, etc for swaps are now available after market.

Yadkin 12-07-2014 10:03 AM

Those engines are good for 250k miles, then they start to pop spark plugs off the heads, casting threads and all!

jhuebner 01-10-2015 10:24 AM

Now have the complete drivtrain in the garage, just going to save it for a hotrod or ratrod project, about to pull the 390 and replace all the gaskets a few questions in another post about the removal

Ford351c594 03-21-2015 12:25 AM

if you are still looking to do this. That is a very wide motor. I would check that. Also look a Ford Motor sport, ( now Ford Racing again) they probably make a stand alone kit for it. PCM and minimal wiring harness to make it run. They have been increasing the out put of these lately. The new 5.0 already has it all already.....

jhuebner 03-31-2015 06:20 PM

For now its covered on a stand thanks for the info, as long as the FE holds on I will too, but it would be cool to have it installed

stubbie 07-03-2016 12:06 AM

Has anyone seen a Barra Engine built by Ford Australia. There is a 6 cylinder Turbo (not sure on these figures as they seem to change wherever you read) 325Kw 576Nm and the 5.4LTR V8 345Kw at 570Nm. The V8 would be way to wide I think but the 6 might fit in. Just.


All times are GMT -4. The time now is 06:09 PM.

Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Any submissions to this site and any post on this site becomes property of Squarebirds.org . The webmasters reserve the right to edit and modify any submissions to this site. All material on this is site is copyrighted by the Squarebirds.org. Reproduction by any means other than for personal use is strictly prohibited. Permission to use material on this site can be obtained by contacting the webmasters. Copyright 2002-2016 by Squarebirds.org.