Squarebirds, Rocketbirds, and Fifties/Sixties Ford Discussion Forum

Squarebirds, Rocketbirds, and Fifties/Sixties Ford Discussion Forum (http://squarebirds.org/vbulletin/index.php)
-   1961 To 1963 Bulletbirds, Rocketbirds - General Technical Discussion (http://squarebirds.org/vbulletin/forumdisplay.php?f=24)
-   -   btiberend Has Questions & Needs Help (http://squarebirds.org/vbulletin/showthread.php?t=15784)

YellowRose 09-10-2013 10:30 AM

btiberend Has Questions & Needs Help
 
Brian has just bought a '62 Tbird that has been sitting for 20 years. It did not come with keys, so he cannot open the trunk, or start the car. He has tried to get the back seat out of the car to get into the trunk to unbolt that latch, using the methods we use for Squarebirds. But he cannot get the seat to pop loose. I have researched some 25 pages of posts for the Bulletbirds, and came up with a couple of links that might help. That seat should just pop out of the clips holding it in place, like the Squarebirds do. Here they are. First of all if you have not read the instructions on how to get the back seat and seat back out of a Squarebird, check this out. It might help. This is right out of the TRL.

http://www.squarebirds.org/picture_g...structions.htm

http://squarebirds.org/vbulletin/showthread.php?t=9025

http://squarebirds.org/vbulletin/showthread.php?t=5977

If this does not help, than hopefully a Bulletbird owner can chime in here. Once you get the seat and seat back out, you should be able to reach into the back following the instructions in the first link.

As for the ignition switch, once you get it out, you should be able to take it to a locksmith and see if they can make a key for it. But if I am wrong about that, someone chime in. Before doing any electrical work, removing that ignition switch, etc, take one of the battery cables off the post.

All of our Tbird parts houses have shop manuals for these Tbirds. The listings for our Tbird Parts houses is found in the Advertisements Forum. The Bird House, the Bird Nest, Mac's, and many more all have them for the Bulletbird. Take a look at the manuals available for the Bulletbird because you will need more than just the shop manual. The electrical wiring diagrams are all in the TRL, which link is always right below my signature element.

Once you get either a new ignition switch, or a key made for the present one, then you can see if the car will turn over. Depending on that, then you will have a good idea of what to work on first. When you start troubleshooting things, it helps us if you post pictures. In my Welcome to you, I told you how to go about posting pix on this Forum. Good luck with your project of bring this ole gal back to life. The guys will do all they can to help you, but to help them, take one project at a time, give us pix so we know what you are looking at and seeing, so we can help you diagnose what needs to be done to fix that problem.

ozbird 09-11-2013 07:17 PM

I have a 62' hardtop, this is how I removed the rear seat:

- remove the seat base (the part you sit on) by squatting above the seat in the middle, reach down either side under the front section and pull up smartly. That should be easy.

- remove both side inner panels, you need to use a phillips head screwdriver and if it's still intact, pull back the plastic covering the lower section, two screws hiding there.

- now remove the shield from the top of the rear seat, use the phillips head again

- almost there, remove 4 nuts/screws located under the rear seat back, they are screwed into the body shell.

I think that's it.
:D
Graeme

btiberend 09-12-2013 10:16 AM

I got it !!!
 
Good morning guys,
I was able to get it out, thank you both for the input, it helped a LOT! I was able to pull the lower rear seat, she was definitely stuck, and required some brut strength, a pry bar, the rest was smooth sailing. I am going to take a bunch of pictures and post them this weekend. I also found the ROT build sheet!!!!

YellowRose 09-12-2013 10:26 AM

btiberend Has Questions & Needs Help
 
Hi Brian, and I am glad you were able to get the seat out and on top of that, found the ROT Sheet! I hope that it is still in good condition. You will want to put that in a document protector and keep it for your records. It tells you exactly what they put on your Tbird as it went down the line. You must have found it in the seat springs, where they often are. I hope you will now be able to get into the trunk and unscrew that bolt that holds the trunk latch in place. Let us know how that goes!

Yadkin 09-12-2013 12:20 PM

You can buy a kit with lock cylinders for both doors and the ignition, all the same key. You'll need the old key to remove the cylinder from the ignition switch, so if you don't have that just replace the switch. Those are available at your local parts store.


All times are GMT -4. The time now is 02:46 AM.

Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Any submissions to this site and any post on this site becomes property of Squarebirds.org . The webmasters reserve the right to edit and modify any submissions to this site. All material on this is site is copyrighted by the Squarebirds.org. Reproduction by any means other than for personal use is strictly prohibited. Permission to use material on this site can be obtained by contacting the webmasters. Copyright 2002-2016 by Squarebirds.org.