Squarebirds, Rocketbirds, and Fifties/Sixties Ford Discussion Forum

Squarebirds, Rocketbirds, and Fifties/Sixties Ford Discussion Forum (http://squarebirds.org/vbulletin/index.php)
-   Golde Top (Sunroof) Forum (http://squarebirds.org/vbulletin/forumdisplay.php?f=20)
-   -   Sunroof Panel Replacement (http://squarebirds.org/vbulletin/showthread.php?t=11606)

kevin_tbird 08-01-2011 07:40 PM

Sunroof Panel Replacement
 
3 Attachment(s)
I am replacing the headliner in my 60 bird and am now ready to replace the vinyl on the sunroof panel.

Mine has a seam sewn down the middle to attach muslin the back and the muslin is then glued to the thin steel piece that is part of the panel frame.

Should I sew a piece of muslin to my new vinyl before installing it. Has anyone else done this?

Kevin

YellowRose 08-01-2011 08:17 PM

Sunroof Panel Replacement
 
Hi Kevin,

After seeing your question, I just fired off an email to Kev in England. He is probably the one person who has a ton of knowledge about the Golde Tops, having owned them himself. He knows a lot about them. I asked him to read your post and see if he could give you an answer.

Rockin Kev 08-02-2011 12:23 PM

Quote:

Originally Posted by kevin_tbird (Post 57940)
I am replacing the headliner in my 60 bird and am now ready to replace the vinyl on the sunroof panel.

Mine has a seam sewn down the middle to attach muslin the back and the muslin is then glued to the thin steel piece that is part of the panel frame.

Should I sew a piece of muslin to my new vinyl before installing it. Has anyone else done this?

Kevin

Kev,
Take the steel surround and make sure you sand down all the lose and bumpy bits of glue, then glue the sliding headliner panel in place at ONE END first, stretch the vinyl over to the other side but not to tight and glue again, make sure you put weights on each end on top of the metal band, to make sure the glue takes a firm hold and an EVEN HOLD you can use clothes line pegs. , you then sew the cental bar into place before fitting, and dont forget the 4 small cross headed screws in each corner...ONE THING TO MAKE SURE do not! sew the central bar into place until the glue has set around the edge of the steel frame to allow for sag, you will get some sag..you can then stitch the central bar then follow installation process from this website.

kevin_tbird 08-03-2011 04:58 PM

So the seam down the middle is factory correct? My replacement panel doesn't have one and I will need to create it if needed.

Kevin

Rockin Kev 08-05-2011 02:04 AM

seam down the middle was factory correct,
Kev


All times are GMT -4. The time now is 01:57 PM.

Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Any submissions to this site and any post on this site becomes property of Squarebirds.org . The webmasters reserve the right to edit and modify any submissions to this site. All material on this is site is copyrighted by the Squarebirds.org. Reproduction by any means other than for personal use is strictly prohibited. Permission to use material on this site can be obtained by contacting the webmasters. Copyright 2002-2016 by Squarebirds.org.