Squarebirds, Rocketbirds, and Fifties/Sixties Ford Discussion Forum

Squarebirds, Rocketbirds, and Fifties/Sixties Ford Discussion Forum (http://squarebirds.org/vbulletin/index.php)
-   1958 To 1960 Squarebirds - General Technical Discussion (http://squarebirds.org/vbulletin/forumdisplay.php?f=14)
-   -   refinishing inside of fender wells (http://squarebirds.org/vbulletin/showthread.php?t=8896)

Dakota Boy 05-31-2010 10:10 AM

refinishing inside of fender wells
 
Cant decide what to do.

Fender wells have some newer undercoating (previous owner applied) on them now. A few spots have some purple overspray from when the car was painted. I'm also going to clean up the brake drums so they look good behind the mags.

Here's what I'm thinking: Eastwood Rust Encapsulator where there is any surface rust. Eastwood Underhood Black in the fender wells, and Eastwood Chassis Black on the brake drums. I think Chassis Black might be too glossy to use on the fender wells; especially on the front where it would be highly visible ?

Opinions and suggestions are, as always, greatly appreciated....

Anders 05-31-2010 12:21 PM

Iīm not aware of Eastwoods products, but the fenderwells must be in a matt colour, preferibly in a undercoat grain & finish.
Regarding the drums I would say matt or semimatt. Not glossy. But priority is something that donīt disapear due to the heat...;)


All times are GMT -4. The time now is 10:31 PM.

Powered by vBulletin® Version 3.6.8
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Any submissions to this site and any post on this site becomes property of Squarebirds.org . The webmasters reserve the right to edit and modify any submissions to this site. All material on this is site is copyrighted by the Squarebirds.org. Reproduction by any means other than for personal use is strictly prohibited. Permission to use material on this site can be obtained by contacting the webmasters. Copyright 2002-2016 by Squarebirds.org.