Announcement

Collapse
No announcement yet.

Diy alignment

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Diy alignment

    Ok guys here we go again bare with me I'm getting close to figure ing this out after talking to John yesterday I am comfortable with rotors calipers and spindle knuckle all being correct . I noticed last night that there seems to be alot of negative camber in the wheels so much that calipers bind on rotors when t try to slide them on . My question is does anyone know of a way to adjust the camber without the alignment tool as I have searched and can't find one I am in a massive time crunch so any info will help

  • #2
    If the car is on a good concrete garage floor, eyeball it to a carpenter's framing square. Will be close for the short term.

    Comment


    • #3
      You want about 1/2 degree positive camber. You can try using a level to get it even from top to bottom and then adjust it so it tilts out a hair. Without having a degree tool that's probably about the best you are going to do.

      John
      Last edited by jopizz; September 28th, 2017, 03:25 PM.
      John Pizzi - Squarebirds Administrator

      Thunderbird Registry #36223
      jopizz@verizon.net 856-779-9695

      http://www.squarebirds.org/picture_gallery/TechnicalResourceLibrary/trl.htm

      Comment


      • #4
        Going by the diagram I can see what you are talking about regarding the tool. I imagine it's doable without it.

        John
        Attached Files
        Last edited by jopizz; September 28th, 2017, 03:20 PM.
        John Pizzi - Squarebirds Administrator

        Thunderbird Registry #36223
        jopizz@verizon.net 856-779-9695

        http://www.squarebirds.org/picture_gallery/TechnicalResourceLibrary/trl.htm

        Comment

        Working...
        X