Announcement

Collapse
No announcement yet.

'62 Door Peak Molding Removal

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • '62 Door Peak Molding Removal

    There is a very good article with a lot of pix in the VTCI May/June Scoop on how to remove the door peak molding on a '62 Bulletbird. This exchange of information, with a lot of pictures, takes place between well known Tbird owner Jim Wulf and Bob Harris on the VTCI Forum. It can be found starting on Page 48, and might be of use to you Bulletbird owners.

    Ray Clark - Squarebirds Administrator
    '59 Tbird "The Yellow Rose Of Texas" aka "Tweety Bird"
    "It's Hip To Be Square"
    Thunderbird Registry #33025 VTCI #11178

    Contact me via Private Message for my email address, or (Cell) 210-875-1411 (Home) 210-674-5781

    http://www.squarebirds.org/picture_gallery/TechnicalResourceLibrary/trl.htm

  • #2
    Vtci

    Hi, being a newbie in the Tbird world can you educate on the acronym VTCI as I am interested on any reading pertaining to bullet birds.

    Tks
    Gas

    Comment


    • #3
      '62 Door Peak Molding Removal

      The VTCI (Vintage Thunderbird Club, International) is one of the large international Tbird clubs one can belong to. They publish a very good booklet called the Scoop. Membership for the year is $35 for US members, but right now, since the year is nearly half over, it is $25. You can find out more about them by going to this link.

      http://www.vintagethunderbirdclub.net/index.htm

      Ray Clark - Squarebirds Administrator
      '59 Tbird "The Yellow Rose Of Texas" aka "Tweety Bird"
      "It's Hip To Be Square"
      Thunderbird Registry #33025 VTCI #11178

      Contact me via Private Message for my email address, or (Cell) 210-875-1411 (Home) 210-674-5781

      http://www.squarebirds.org/picture_gallery/TechnicalResourceLibrary/trl.htm

      Comment

      Working...
      X