Announcement

Collapse
No announcement yet.

Convertible top WStrip adjustment and shim

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Convertible top WStrip adjustment and shim

    1959 convertible.

    I looked in the TRL but didn't see anything on this adjustment.

    The top is latched.

    This is the initial fit. The strip starts flush at rear of the window and progresses to the front above the vent to a gap of almost 1/2 inch. I realize that some shimming is required but that seems excessive. Is it? I don't believe I can raise the division bar to solve this or can I? What are you all using for shimming material?

    Thanks.
    Attached Files

  • #2
    That doesn't look like a weatherstrip issue to me. It looks like the header bow is too far forward. It could just be the angle of the picture. Is it sitting flush on the windshield header? Are the dowel pins inside the header holes? Have you adjusted the frame according to the top manual?
    http://www.squarebirds.org/picture_g...djustments.htm

    John
    John Pizzi - Squarebirds Administrator

    Thunderbird Registry #36223
    jopizz@verizon.net 856-779-9695

    http://www.squarebirds.org/picture_gallery/TechnicalResourceLibrary/trl.htm

    Comment


    • #3
      I have adjusted the header and the pins so they repeatedly engage their holes. The header is compressing its new gasket as tight as I can get it and the latch hooks have been adjusted.
      I had to do extensive metal replacement on the header due to rust outs. Hopefully I got it right.

      I will look over the material you provided and see where we end up. Thanks.....

      Comment

      Working...
      X